-
Posts
85 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Community Map
Posts posted by mwspit1500
-
-
hi Longboarder
that's excellent, i've got them the wrong way, i'll will try the other way see how it goes.
cheers
mark
-
my old setup was servo-less, i've done some research and i have probably got some air in the master cylinder, i didn't fit a bleed nipple to it just a pipe with some solider in the end, i'm just unsure if the pipes are in the right holes.
mark
-
bore size is 20.6 mm, all standard ford sierra brakes, discs front and drums on the rear, the peddle is solid, but when i brake its like they have brake fade,
mark
-
hi
i have fitted a Fiat Punto master cylinder, i've bled the brakes and is no air in the system, test drove and the brakes are rubbish,
do i have the pipes in the right place?
Mark
-
update,
I changed the friction plate to a Mondeo MK 1 and also changed the pressure plate to the Mondeo, all working fine.
thanks again for your help
Mark
-
Longboarder, tractor,
Thank you.
Mondeo plate on it's way.
Mark.
-
I have the 5 speed type 9, didn't think I needed to change the pin as I'm using the larger Capri bearing,
-
Had the engine out today to check i had it the right way and it was, what clutch set up do you have ?
-
The zetec plate doesn't fit the gearbox spines
-
Hi, Can anyone tell me what I'm doing wrong?
The clutch peddle feels normal but I can't get it into any gear, it's a zetec onto a type 9
I have 1.8 flywheel with a sierra friction plate and zetec cover plate with Capri bearing.
Mark
-
Thanks tractor, I couldn't have done it without the help of the club, too many people to mention, so thank you all.
Mark
-
-
Hi,
Going bike carbs with megajolt, had the engine running this weekend, really pleased with the progress.
Cheers....
- 1
-
PM sent
-
-
hi,
project is going well, a bit slow as i have other projects on the go, ill post some pictures later,
cheers
mark
-
thanks for the replies, ill have a look into the tie-bar conversion...
mark.
-
thanks for your help tractor, ill figure something out.
mark
-
tractor,
did you do anything with the anti-roll bar?
mark
-
-
gents
has anyone put a zetec with race-line sump into a 2B/4...?
if so how...?
Mark
-
thanks for that, i'll give it a go.
mark
-
Gents
My winter project this time round is fitting a Zetec into my 2B/4
My first task is to make the engine mounts, so, my question is, anyone got pictures of theirs? Or maybe drawings.
Cheers
Mark
-
571
cheers
Tie Bar plans
in Mechanics
Posted
when i was doing my Zetec engine change i needed to remove the ARB, i did what some members on here had done and cut the ARB instead of fitting tie bars, i cut it just to the mounting and welded a big washer on the end to stop it pulling through, i have some pictures if you want to have a go.
mark.