flameredturbo
-
Posts
346 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Community Map
Everything posted by flameredturbo
-
Thanks again!
-
Zetec using 1.8 zetec flywheel. Is this the right one? http://bit.ly/1aeeRJZ Thanks in advance
-
Sold to hoppo.
-
Sold to maccavvy.
-
As photo, with pipes £45 £10 post
-
£40+£5 post As title, Happy to email photos Rich
-
Good luck with it all, keep us posted with pictures.
-
Have you fully assembled the engine with a view to dropping it in as complete as pos?
-
I might just get away with it then! I'll have to measure tomoz to be sure and see what extra space could be gained with a hammer if needs be, ideally no hammer needed as I'm hoping to keep it all near and tidy.
-
We'll I'm having a crate zetec being delivered tomorrow so I'll have a pallet, I'm happy to load it onto a pallet and get details from them tomorrow, I've paid £75 so I'd say its likely to be in that price bracket. Pm if still interested.
-
Picture to follow, exits at the side. £40+ £10 to post. Any questions please ask.
-
For sale, currently sat in car so can be seen and heard running. 2.1 Maxiflow head unleaded Kent FR32 cam Not 205 as far as I'm aware. With invoices from original owner. Engine with flywheel only, most other parts being kept or sold seperatly. Feel free to ask any questions £250 Cr8 Surrey.
-
Thanks! Fingers crossed!
-
That's what I'm trying to avoid, also after looking at my bulkhead trimming a couple of inches off shouldn't be a huge issue.
-
How much clearance is needed to run a blacktop without a water rail? I've measured and my bellhousing seems to sit nearly 3 inches further out than my bulkhead. Will I have enough clearance for the standard thermostat housing? I've searched and can't seem to find any info. Thanks in advance!
-
Thanks, I've got the swirl pot already so I'll go ahead with these bits. Thanks again.
-
The below ok? Low pressure to feed swirl pot then the high to feed the injectors... Thanks in advance. Just seen very similar set up on photos of other cars but would like to confirm. http://bit.ly/1cJ38sv Low http://bit.ly/1b47Cqn High
-
I was seeking clarification if anyone knew of any or had in fact bought a set from somewhere. Think I'd be better off finding out how my engine bay differs from later Mk s7's and then I might be able to seek advise on what they used. Thanks for replies.
-
Cortina based s7 or does that make no odds?
-
Ok, put another way, do any off the shelf mounts exist for a cortina based s7? Anyone know?
-
Present rubber mounts? I'm pulling out a pinto and dropping in a zetec. I will admit I'm clueless with certain aspects as I didn't build the car.
-
Any one know of where I can get hold of suitable mounts? What have others used to drop a zetec in a cortina based car? These? http://www.retro-ford.co.uk/shop/content/zetec-diy-engine-mount-kit-z006
-
Hi, where did you get your engine mounts from? I've got quite a few of the bits to put a zetec in my s7 now but engine mounts are still on the list.
-
I'm after fast road, I will track the car I'm sure but I get more day to day fun out of it on the road.
-
While we're on the subject of zetec cams, any opinions of the best and best value fast road kits on the market?
