Jump to content

RHOCaR End of Season Bash 

Come and join us for our Annual event  on 14th to 16th September

Camping, Family Fun,  Evening Entertainment and like-minded Company


Full Details and entry form here:



- - - - -

Exmo Camber Problem

  • Please log in to reply
4 replies to this topic

#1 Mph28


    Newbie Builder

  • Community user
  • 3 posts
  • Location:Wigan
  • Car type:Robin Hood Exmo

Posted 14 June 2018 - 07:12 AM


after my car ( Exmo) failed on front track control arms bushes i have replaced them but now have camber issues on the drivers side only.

the wheel now have very noticeable positive camber on the one side only.


I cant see any way to adjust camber at all


Thanks for any replies in advance




#2 jaimo


    Wheely good builder!

  • RHOCaR 18
  • 1,699 posts
  • Location:south yorkshire / doncaster
  • Car type:robin hood exmo

Posted 14 June 2018 - 08:00 AM

Have you moved the car to settle the suspension
Will it ever be a good runner ?

#3 brumster


    Wheely good builder!

  • RHOCaR 18
  • 1,368 posts
  • Location:Brum (duh)
  • Car type:Zero

Posted 14 June 2018 - 08:11 AM

Well I suppose the obvious answer is, did you check that the control arm is the right length before and after? A common fit was P100 arms and bushes as the bushes were slightly "stiffer", I believe...? Maybe this resulted in it holding the arm slightly tighter in position?


Otherwise if it was fine before and now it's not, I'm not sure what else it could be, assuming the top mount hasn't moved into another hole, or maybe it's slotted in some way and has moved outward?

Edited by brumster, 14 June 2018 - 08:13 AM.

#4 Alantoon


    Wheely good builder!

  • RHOCaR 18
  • 396 posts
  • Location:Cramlington, Northumberland
  • Car type:Robin Hood 3a.Robin Hood S7 Dolomite Sprint

Posted 14 June 2018 - 04:23 PM

Check that the spring is sitting properly on its top and bottom seats, if not seated properly it could be lifting that corner and giving positive camber. When i had mine after it had been jacked up the spring would sometimes give acrack as it settled into position

#5 Mph28


    Newbie Builder

  • Community user
  • 3 posts
  • Location:Wigan
  • Car type:Robin Hood Exmo

Posted 14 June 2018 - 04:47 PM

Thanks all.
Sorted it this afternoon.
Wrong part supplied,new one about 20mm shorter. New parts collected and fitted problem solved.
Thanks for pointing me the right direction