Machined Anti-roll Bar

[SSSLINE]

Anyone who has gone for tie-bars got a machined front anti-roll bar they would like to sell?

 

Cheers

Tony.R

[Snapperpaul]

Not right now but it is my next modification, i will post when i get the mods done and the milled anti roll bar becomes available.

[Guest robinj66]

If i wanted to fit the tie bars to my S7, would I need to use solid bar or would seamless tube be OK?

[SSSLINE]

Not right now but it is my next modification, i will post when i get the mods done and the milled anti roll bar becomes available.

 

Cheers Paul

I assume it did make a difference, just not as much as tie-bars would though?

Thanks

Tony.R

[Peter Bell]

solid bar or would seamless tube be OK?

I'm sure a decent tube will be fine, it is in a compressive load (unless you go backwards!) and will have far less complex stresses than a tubular wishbone!

[Dave Ed]

Snapperpaul,

Do you have any info on how much you had the ARB machined by? what was the final thickness?

Was the top and bottom machined or just one side?

I'd love to do this to my Exmo once i've done the re-wire and the dash and the boot and the .......

have you got any before and after pics please