Jump to content

Sierra Column Stalk Wiring


steve_wilson

Recommended Posts

Hi Steve,

I had the same problem and was not able to find anything off a newer Ford that would fit either.

 

So I ended up soldering wires to the pins and pushing a PTFE sleeve over each terminal to isolate it.

Then I took the wires out to one side of a set of Molex connecors to make it removable. Made a nice clean job in the end!

 

It's a bit fiddley and you have to take care not to get too much heat on the terminals as you could melt the internals, but it may be an option if no one has any at the bottom of their parts boxes (or man draws!).

 

Cheers

Paul

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...