Zero Rear Arch Sides

[danielbrookes]

Have searched but can't find answer anywhere, I'm doing some prep for attaching rear arches this weekend. Are they different sizes each side?

 

I see that kitspares sells them as NSR and OSR so they must be - how do you know which side is which?

 

My wife says they look different but I can't see it however measuring them one side is wider than the other. Widest to the rear of car?

 

Feels like a daft question but thanks for any help.

[Guest 2b cruising]

You will see the difference when you come to fit them.

Unless you Fit the o/s to the n/s (right to left).

That would look very different to any other because your rear end would look backwards.

The front of the wing is much different than the rear.

[danielbrookes]

Perfect, thanks again.

[fry61]

Take a close look at the wings around where you would expect the lights to fix ( check both ends of each wing ) as the 2B wings had very small indetations where to driil for the light fixings.

 

May be different for the Zero though.

[knights_templar]

the difference can be seen here

 

http://www.greatbritishsportscars.co.uk/zero-gallery/

 

its the angle of the wing edges nearest the ground

Edited May 17, 2016 by knights_templar

[Guest 2b cruising]

Even 2 b's had different wings.

Make sure you get the right ones.

Half s/steel with fibreglass outer edge.

Full fibreglass, fitted just to side panel.

Full fibreglass one piece to rear panel.

Sorry it seems so complicated but I know what I went through getting some to fit my car last year.

Mine were the final ones.

According to GBS, the superspec unfortunately fit the standard 2b. Shame as they do follow the wheel size much better.

Edited May 17, 2016 by 2b cruising

[danielbrookes]

Ahhh. *click*. Finally twigged, thanks all. For some reason yesterday I couldn't see it but if you lay them flat on their sides and check the angles each end, the rear is obvious.