Landie

Thanks Alan.

Thanks Alan,

I was looking for some padding in the seat, as I have a bony bum , but they look good and have runners, do you a price in mind?

Phil

Thanks Foz, didn't think that!!

It's for a S6 Barrel back and side to centre tunnel is around 16 to 17 inches.

Phil

Hi,

I'm looking for a pair of seats, preferably bucket seats, but any type considered.

I'm in Essex but can travel.

Thanks

Phil

Thanks Richy.

I was maybe sure that the stub axle/disc/brake calipers were Cortina, but not sure about the rest.

Hi,

Having found out that my R/H has a cortina rear axle ( thanks Bob ) and everyone else, I was hoping that someone might be able to identify the front hubs & dusc setup ?

Thanks for looking.

Thanks Guys, for all your great ideas, I will check out all your links and measure my gap and what I fit on the carb.

Christmas hols job, instead of watching the Two Ronnie's!!

Thanks Hawknorth

I probably agree, just finding a very thin type of Pancake filter or cutting a hole in the bonnet, which I don't want to do!

Maybe a mesh type filter that I have on my Triumph bike?

Hi All,

I have a S6 Barrel back with a 1600 pinto and it looks like a Cortina\Ford carb, but it doesn't have a filter on the carb and there's very little room to fit one, between the bonnet, is it okay to run it without a filter?

Thanks Phil

Hi Bob

Thanks for the photos, I'm sure the rear axle, on my R/H is Cortina and the wheels are from an early Ford Focus, and the front axle set up, is a bit of a mongrel.

Thanks Ian, I'll check that.

Hi Peter 

Sorry not sure what "pcd" means.

Phil

Thanks Guys, I wasn't sure if R/H suggested or dictated what donor car is used for each kit, but I'm finding out that doesn't seem to be the case.

Maybe that's why it's a Q plate, its been built from may different cars! Just a real pain to get spares, if I don't know what car I'm looking for.

Okay thanks Steve.

Hi Everyone,

I'm very new to kit cars, I have just bought a Robin Hood Barrelback and I'm not sure what the donor car was for the suspension and back axle, would someone be able to help?

Thanks Phil