Pinto 2.0l Carb With Manifold Wanted

[keith kelly]

hi all,

i am after a bolt on ready to go carb and manifold for a 2.0l pinto engine until i get the bike carbs and manifold sorted. will need water and vac take off but think that standard on the basic carbs anyway.

 

PM me if you can help.

 

regrads

 

keith

[theduck]

Also need these, obviously first refusal to op if they haven't found one yet.

[Dave R]

i will have a dgas and manifold available soon

jetted to suit 2l pinto with 285 cam

[Guest ickle]

i have a twin choke that i paid 30 quid on ebay for i started to strip the auto choke of it but decided to stick with the bike carbs i had. as far as i am aware it runs fine but cannot promise as i never tried it also have a manifold to suit again never had fitted. say £40 quid for both plus postage?

 

regards stuart

[keith kelly]

dave, sounds good are they easy to re-jet. go dcoe and they are faily simple. any idea on what sizes for a std cam??? What would you want for them. northants not far.

 

Ickle

thanks for the offer will see the outcome of the above may come back to you

 

regards

 

keith

[Dave R]

very easy to rejet

you may not have to, as the 285, is only longer duration, not higher lift, so only draws fuel as hard as the standard cam, just longer

 

the choke flaps have been removed, you dont need them in the winter, just a couple of pumps on the pedal it starts.. i could never be bothered to put a choke cable in

 

not sure what i want for it, give me a week, to finally commit to the fact i am going to go duratec, and i will let you know ?

at the moment all my work is reversable, and the pinto could go back in

 

dave

[keith kelly]

well if the whole engine is up for grabs let me know! will have to keep an eye on you if your going duratec as that would be my engine of choice if i had the pennies spare.