2B Dummy Struts Wanted

[Guest donaldthomps]

I was a little too eager with the grinder when I cut off the old arch supports.. I have cut into the top and think I would be risking losing a wheel should it break..

 

Does anyone have a matching pair of this laying around?

[Bob Tucker]

Just weld it up....someone local should be able to help....maybe even RHSC?

[fry61]

If your upright still has a thread in (M12 I believe) put the bolt in back to front - screw in til just visible in the slot - place a thick washer/piece of steel in the slot & screw bolt in to open sleeve up for the strut to just slide in -- much more controllable than a 'driver wacked in the gap.

[speedtripledan]

I was a little too eager with the grinder when I cut off the old arch supports.. I have cut into the top and think I would be risking losing a wheel should it break..

 

Does anyone have a matching pair of this laying around?

I,d weld it if it were me, drop them off and i could do it for you over the next week or so if that helps