Which Clutch?

[tractor]

If you are using Mt75 you can use standard zetec clutch and flywheel GBS sell a longer clutch fork pin to re aling the fork to the right angle if you are using a type 9 then a 1.8 flywheel gives you two choices with clutch you can fettle pinto clutch to fit or use a 1.8 zetec clutch and a longer thrust bearing hmmmm choices

[danielbrookes]

Tractor - MT75, it's all ready to go (hopefully!) I've got the extended pin from Gbs along with the release bearing and spigot bearing and it's been refurbed as new.

[danielbrookes]

Before I bite the bullet, does anyone know if this will fit? Its for the ST170, which I believe is a Duratec and I have a Zetec blacktop:

 

http://www.ebay.co.uk/itm/Ford-Focus-Dual-Mass-Flywheel-DMF-for-Clutch-415025810-LuK-1310280-3S4Y6477AA-/231503407278

[tractor]

St170 is a zetec it's just the head that is different

My St170 had a dual mass flywheel binned that and put a 1.8 zetec fly wheel on

Edited February 25, 2017 by tractor

[danielbrookes]

Thanks, that's good to know.

[Allan Royds]

Hi Daniel.

Have you checked the crank senser mounting ,thats the ali piece which is installed on the flywheel side of the engine block,

As there are two types one for auto and one for manual gearbox one short one long can't remember which is which but the auto one will not work with a manual flywheel.

Where did you get the box reconed?.

Allan

[danielbrookes]

Hi Allan, hope you are well? I took it to a place in Stockton round the corner from work - they told me it was in pristine condition already, which was great . EazyGears I think they were called.

 

I'll check the crank sensor, thanks.

Edited February 25, 2017 by danielbrookes