Pinto Rocker Cover Brackets - Hose Clips Needed

[Guest donaldthomps]

Hello all,

 

See highlighted on the attached photo - I tying to find the clips that fit into the rocker cover so that my water hose can be raised rather than leaving it under the manifold.

 

Does anyone know the names of the clips / brackets or where I can get any?

 

I could use plain ole tie wraps, but....

 

Thanks, Donald

[cb750]

The clips that go in those holes hold the HT leads up out of the way

Rob

[Dave R]

on my pinto, i had brackets that came off of the rocker cover fixing bolts..... may still have them

[MarkBzero]

Hi Donald,

Some on ebay item number 390535075431

[Guest mower man]

As above plastic clips to hold ht [plug] leads I have never bothered but they are a good idea , support brkts from cam cover bolts also available from numerous sources ,see you next week some time regards mick

[Guest donaldthomps]

Hi Mick, decided to get shot of the bike carbs, the airfilter means chopping the car up a bit - Im passing on this..

 

http://www.rhocar.org/index.php?showtopic=35863

 

Will give you a call over the weekend.

[Andi]

I cut some ally strip into inch long bits, put a rivnut through the centre of each one, put them behind the holes and screwed a P clip to each one. The hose (or bit of chrome bling copper pipe in my case) then runs through the P clips which holds it nice and secure.

 

Andi

[Guest donaldthomps]

I cut some ally strip into inch long bits, put a rivnut through the centre of each one, put them behind the holes and screwed a P clip to each one. The hose (or bit of chrome bling copper pipe in my case) then runs through the P clips which holds it nice and secure.

 

Andi

 

Hi Andi, would you be able to take a pic and send please?

 

Sound good, would like to see if possible.

 

Thanks, Donald