Twin 40S Linkage

[theduck]

Mounted my twin 40s to the pinto manifold tonight and the spacing on the pinto manifold is different to the spacing on the XE manifold I took them off so now the linkage between the two carbs is too short (see photo).

 

Suggestions on where to buy a suitably longer lever? Preferably west mids area so i can take the carb along and make sure i get the right one.

 

Or ideas to neatly extend it?

 

[Guest arf!!]

opsss!!! just look again mmm! get some one to braze a small piece on to the end

Edited June 27, 2013 by arf!!

[Snapperpaul]

Measure gap

Call Burton Performance

[theduck]

I don't know what make the original linkage is though paul, hence I want to take it somewhere to be 100%

[Jez Morton]

Aldon Automotive, Brierley Hill.

Listed as a Webcon dealer.

[theduck]

Tried aldon earlier, normally very helpful but didn't want to know and just referred me to Eurocarb in reading.

[Bob Tucker]

Thumbs up for Eurocarb.....very helpful with a jet problem I had a while ago..

[theduck]

Good to know bob. May have to give them a call, just ideally wanted to be able to go in somewhere and make sure whatever I got was right rather than mess around with mail order.