Jump to content

Recommended Posts

Posted

Hi all,

I have purchased a project which was started by someone how hasn't looked at the vids and the body panels have been butchered to fit they have folds/dents where they have been forced to fit. So I,m looking for body stainless panels, near side full panel, rear panel, footwell end panel, I may need the offside panel because I believe the exhaust hole has been cut wrong. I would advertise this in the wanted section but I am having problems paying for membership without PayPal. 

Thanks Ian

Posted

GbS can supply all the panels but they're not cheap. You might be best just getting only the visible ones in stainless and make the rest yourself using card etemplates and transfer them to Zintec sheet. 

Posted (edited)

Ian, I have a selection of stainless sheet, but you would need to bend it yourself or have access to some-one who could bend it for you.

Florin is mainly stainless which we formed ourselves.

We are way down south so maybe too far away.

See what the prices are from GBS  & then maybe give me a nod on my e-mail   sylvia.fry2@btinternet.com 

DSCF7026.JPG

Edited by fry61
Picture added.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...