Open frame plans

[Lee blaney]

So new guy , not new to car builds , built a few interesting things 

Got a rolling  2b  with engine etc  panel work is terrible and then some 

I'm liking the idea of a open frame  car with nose cone  bonnet and cycle fenders 

Obviously  no sharp protruding edges etc  I understand , and there's been things like the atom and vw Sand rail buggy 

Can anyone see issues with the iva in this regard ?? 

[richyb66]

Sharp edges are the only things I can think of, if they're not contactable it should be fine.

[phaeton]

Less is more, only put on it what you need to, add everything else after IVA, if you are going to use square tube, check the radii of the box section

[MarkBzero]

Probably a little attention to detail with clips, fuel and brake pipes that will be visible to the tester. Uniformity and straight lines, insulated wiring terminals will fill the tester with confidence of the build.