Helping hand

[Gunby1990]

Well im getting close to the point of iva. Well the point were i dont know what else is to do unless i get my fail sheet.  Im stuck on the last couple of bits mainly seats i need to move the drivers back and do some more reinforceing. Also need to wire up the reverse light. Im wondering if there is anyone local to county durham who knows his stuff and beem through iva who could come and check over my build and help me with the seats. My mechanic skills and electical skills are limited i can follow a haynes manual thats about it dont mind paying an expert to come help 

[richyb66]

Just a few points, your fog light lens should be vertical (easy to do on the day), but it also looks quite low. The bottom of the lens should be at least 250mm above groundline.

I can't see the brake fluid sticker near the reservoir. Section 09D part 17

Steering wheel might need a padded centre, the Mountney wheels have failed some tests.

[Gunby1990]

Took note thank you

[IanS]

Reversing light is not a required light.

But if fitted must work either automaticaly when reverse selected and engine running or with a manual switch and warning light ( it has been a very long time since I last saw this )

[wanderer]

you say its a s3a are you sure? looks like a 2b to me

[Gunby1990]

10 hours ago, wanderer said:

you say its a s3a are you sure? looks like a 2b to me

Yes this 1 is a 2b pne of my 1st postes on here was a 3a but i got rid of that and got this 

[MarkBzero]

Hi,

Lools.like a good build, don't worry about failing most cars do. You then have a nice to do list.

Have you got a rear number plate light?

[phaeton]

On 1/24/2021 at 9:55 PM, IanS said:

Reversing light is not a required light.

Beg to differ, under SVA they were not required, under IVA it/they are required (Section 29)

Edited January 30 by phaeton