Daveo

Hi , I had a similar problem 3 years ago If you dizzy connects with a plug from the wiring harness on the dizzy check it for corrosion mine did the same thing I replaced the plug in the dizzy and the harness hey presto all good. just something else to check.

Hi The Sierra one is also a pinto every thing should just swop over 99.99% .

Hi you could try reconditioned plates and flywheels i used a place in leeds but i`m sure that theres someone near you that will do the same thing i have included this website so you get an idea CG Motorsport - Performance Clutch Specialists they refurace the flywheel on all flywheels and if its a duel mass again surface and new tension springs they aldo will resuface you original clutch plate so its all like new.

try this guy for a rack as alot of ford spares pedrosky666 on eBay

I would look for some more while welding can be done the rust is eating away under it you could try this bloke i have used him nice willing to help pedrosky666 on eBay

hope this helps.

I had mine rebuilt it looked better than new and is still works great. you can try people like this Starter Motors | Reconditioned Starter Motor | Cheap Prices or search via web browser "starter motor reconditioning"

LOL

3/16th drill bit 3 seconds later out or as HawkNorth said grinder , less than 3 seconds only made out of ally.

make one get gasket paper from auto supplies then put part of the paper on the opening for the thermostat trace round , cut out takes about 20 mins money saved when putting it on use a small amount gasket sealer both sides .

Radiator Hose Ford Sierra 2.0 Upper for sale | eBay They have bottom and top there is the flex one by gates.

try the above

GENUINE BRAND NEW FORD SIERRA PINTO SOHC CARBURETTOR FUEL VAPOUR TRAP | eBay try this...