tractor
RHOCaR Member
-
Posts
4,797 -
Joined
-
Last visited
-
Days Won
106
Content Type
Profiles
Forums
Events
Store
Community Map
Everything posted by tractor
-
i had a two inch collar made out of ali then cut the LR pump down works a treat and only takes a couple of hours i now you are getting frustrated with the problems you are having but the the system i have works and there are a few others that have it as well with no problems
-
ooo nice but pricey
-
Oh no there aren't any markings on my glasses
-
I fitted the land rover one to mine no problem and I have just upgraded pump to a Walbro 8 bar which fitted in the swirl pot nicely
-
once i got rid of my pinto engine found i didnt need to carry tools anymore
-
thanks
-
eh jaimo wot colour are the temp sender and oil sender wires on the premier loom i have lost my info
-
eh i go to stoneleigh every year its just you are normally sleeping off your hangover Andi ok last year i only went for the day and not in the kit cos it wasnt finished
-
DanE no time to get it to dyno before stonleigh but after that yes will be going to dyno when he has a spot
-
eh Oz now i dont smoke i dont drink and i have no friends wot else i am i going to do with my time and money
-
Yes I can set an AFR target
-
If I can make 220Bhp I would be happy with that
-
Yes got a wideband getting a steady 14.5 at idle and reving to 3500rpm it drops to 12 but this is just reving it on the driveway have yet to do a data log rain has stopped play
-
this is where i am up to with fuel map i am deliberately keeping it rich at the moment
-
i have loaded Matts fuel and ignition map been having a play with the fuel map today just reving to 3500 rpm and adjusting map to keep a rich afr but need to drive it to do more tuning
-
was hoping to get out for a test drive today but the rain stopped play
-
got a few holes in the bonnet now
-
had to raise bonnet to fit the massive turbo i do intend to remake the bonnet and scuttle and nose cone eventually
-
i have had to relocate battery
-
broom broom
-
been at it all day today inlet valves replaced nearly finished building it back up inlet plenum on tomorrow change the injectors then wire fan into ecu and nearly there just got to figure how i am going to do the bonnet
