theduck
-
Posts
4,526 -
Joined
-
Last visited
-
Days Won
115
Content Type
Profiles
Forums
Events
Store
Community Map
Everything posted by theduck
-
Thanks biksz that would be good to see. It's come out a lot neater than expected but ideas to get it looking spot on are appreciated.
-
Will be an 86 engine then.
-
http://www.burtonpower.com/tuning-guides/tuning-guide-pages/ford-manufacture-dates.html
-
Will be engraved on the manifold side and will start with two letters.
-
Thanks Chris. Just trying stop it looking messy. I've wrapped all the loom this after ion and secure it and it doesn't look too bad now and can't be see unless looking under the dash, ie can't be seen from driver or passenger seat.
-
There is a brace bar on the s7 which is about the only place you can secure the wiring to but your feet pass a long way behind this.
-
Do people tend to box in the underside of the dash to hide the wiring? I'm in the process of tidying it all up and even when finished and secured in place it's still going to look a bit of a mess.
-
We've got a round pine dining table that needs a New home.
-
Offset is a measurement for all wheels, it measures the distance from inner edge of the wheel to hub face. I wouldn't use 2 sets of spacers, and buying proper spacers will get very expensive quickly! You need to use proper hub centric spacers.
-
Pm on its way
-
I got some sorted yesterday. Used 80mm so plenty of room for wing stay brackets.
-
I wish the same members of staff were in when I go to my local place. Never see the same person twice.
-
As above, both ends on mine and definitely needs gluing in place!
-
Need to have a minimum height of 70mm and fit a 70mm wide and 40mm heigh rectangle inside the glazed area. As per diagram below
-
Interested in the carbon ones if they are IVA ok?
-
Cheers. Typically they had 40mm and 130mm but nothing in between.
-
Cheers Ian, had it in my head that it was a 19mm head. How long should the thread be?
-
I'm not with my car and forgot to check before I left home, can anyone tell me what size the pinch bolt for the dummy strut is?
-
Whole section on lightweight issues on here. It's worth the part plus crap value of the chassis.
-
SOLD
-
Limit per post I think, can't remember how many but had this problem on my wiring thread.
-
In fitting to the chassis then believe yes. Though shafts are also different iirc.
-
In my opinion, unfinished is more rewarding but a bigger project, and possibly more expensive when you allow a grand on top to get it through IVA and registration. Road legal and modify is easier.
