jaimo

Going to try and get there

Dan st do a gasket to mount intake manifold its bigger and better quality seals injection head brill

I havnt recieved mine or membership card etc and paid up for 2017

I havnt recieved mine or membership card etc and paid up for 2017

Well garage done for now got to board insulate wall and round new back door and take a bit out step on wood under one wheel but will be done next week but she home

Congrats mate and all the best to you, clare and the baby treasure it mate blink and there in secondary school

Get it done to cover warranty etc then have it remapped just had outlander mapped and now 190bhp 450nm of torque and what a smooth effotless drive Was going to sell but not now Well happy

Going to try attend as outlander getting remap later so bd a gud run out check hopefully get there owe ivan and andrea a drink

Well dumped the 3 ton of rubble out of garage and now realisead as bob said some of panels wet through its not ventalation as not yet sealed like a wind tunnel to be honest So whats best way to stop this Such as insulate etc

Sorry to hear this terry We both been lucky in the past few years And once again mate someone was watching over you again Speedy recovery mate Walk in park for you though after what you been through somebody up there give terry a break

Well first outbuilding out just one to go

My outlander diesel is doing 43mpg genuine

Looking at buying an evoque dont think will be at good at that one though

Well roof on few finishing of bits to do and door set up still got to seal round frame Dubious about knocking wakls out Do i need lintels i wonder

Not thought about it yet but the pasage in outbuilding walls do get wet especially as the kitchen door into in so will go into garage How amd what with to line bob

Outbuilding as they are first 2 are going

Well finally got the prefab panels and door on Roof goes on tomorow then got to look into removing outbuilding walls and rsj etc and level floor as raising about 2-3 inch where buildings are thats where help required The panel area is near as dame it 10ft long and 10ft 6inch wide when walls remoued will be 19ft ish long and narrows slightly

Hope you sort it soon kevin i know exactly how you you feel one step forward and 2 back

Welcome to the modern vauxhall era chris I used to remove the whole egr system every year and clean on my vectra when i serviced it but wasnt a bad job

Not like you to be that quiet keith

I am waiting to build garage when council send me permitted development letter then winter mods will commence and theres plenty so will keep you all entertained

I think you have been to see femi paul

Looks like my exmo under cover

Also boost valves are a problem area as well

Look at this on eBay http://www.ebay.co.uk/itm/261583856761