O M G !

[tractor]

[tractor]

got this off flebay to help with rewire a complete sierra wiring loom gulp theres loads of it think it will take me a day just to untangle it

[cb750]

Good luck untangling that lot!!

[agent_zed]

just install it like that and tuck it behind the dashboard

[Guest Howtightpet]

Last time I saw a mess like that I was driving past spaghetti junction in brum

Get the kids on it they may make a dinosaur out of it.

 

Good luck

[keith kelly]

I don't think that is going to help!

[tractor]

probably not but at least I get lots of wire and plenty of connectors

[Guest davidm]

Looks straightforward enough to me. What's the problem?

[speedtripledan]

I weighed the last sierra loom in. Got £10. By the time you sorted that lot you could rewire the car from scratch

[IanS]

In my build removing all the unused bits of the loom more than halved the weight of the loom.

[Guest 2b cruising]

Oh dear oh dear. Start it before the pub and not after. You might end up with a bigger knot.

[fry61]

Very carefully lay it out on the sitting room floor --- running the groups of wires to where they would have been on the donor-- then sit in the middle & go --BRMM BRMM

[WallerZ]

I've got the Mx5 loom sat in a box ready to untangle and sort out. I'll drop it over when you're done with that one

[Guest 2b cruising]

Very carefully lay it out on the sitting room floor --- running the groups of wires to where they would have been on the donor-- then sit in the middle & go --BRMM BRMM

Dont forget the banging and popping noises

[tractor]

well today I thought I would get the new dash panel cut and fitted I got it two years ago from Stoneleigh its the fibreglass one from gbs they said it would fit the 2b its for the zero really so I carefully marked it out using the old dash for template got a very fine blade for jigsaw and then cut it out went to fit it in the car and oh poooo I had marked out the template the wrong way round but never mind I carried on trimming and trimming till I got to the point of this is never going to fit so I binned it and remade it out of hardboard again just got to find some decent stuff to cover it with